IT IS IMPORTANT TO KEEP PHOSPHATE LEVELS BELOW 0.015ppm

ROWAPHOS WILL ABSORB PHOSPHATE ,SILICATES AND ARSENIC. IT IS ENTIRELY SAFE IN BOTH FRESH WATER AND SALT WATER SYSTEMS. IT DOES NOT RELEASE BACK INTO THE AQUARIUM ANY OF THE ABSORBED MATERIALS .

IT HAS BEEN USED IN SET UP TANKS FOR THE LAST FOUR YEARS  AT FIVE TIMES THE RECOMMEND DOSE, AS AN INDICATION PHOSPHATE SHOULD BE MONITORED WEEKLY AND THE  ROWAPHOS REPLACED WHEN A RISE IS DETECTED.

BY USING ROWAPHOS YOU WILL SEE NO ILL EFFECTS AND NUISANCE ALGAE'S WILL BE COMPLETELY CONTROLLED ,GREAT FOR PLANTED FRESHWATER TANKS. IF YOU ARE USING ROWAPHOS IN A SALT WATER INVERT TANK CORALS (HARD & SOFT) WILL GROW UP TO APPROXIMATELY THREE TIMES FASTER WHEN NO PHOSPHATES ARE PRESENT.

ROWAPHOS IS SIMPLE TO USE , IDEALLY IN A EXTERNAL FILTER OR ON TOP OF A TRICKLE FILTER WHERE THE WATER CAN BE RUN THROUGH THE MEDIUM SLOWLY TO RECEIVE GOOD CONTACT TIME.

   EACH 100 ML TREATS   =   600 L - 132G  FRESH WATER

                                               200 L - 44G SALT WATER

( AMOUNT REQUIRED TO REMOVE 1.ppm PHOSPHATE  )

Instructions for use of RowaLith C+:
This material must be washed very very thoroughly before placing inside your Deltec Fluidized Reactor, if you do not do this the reactor will run cloudy.

RowaLith-C is a natural material specially chosen to produce the highest calcium output in your Deltec Fluidized Reactor.

Set the reactor to run between 30 to 40 dKH. Measure the water from the reactor after allowing it to run for a few hours, from the output flow.

Due to the efficiency of the fluidized reactor constant top up of this material will be required.
Please ensure that the calcium levels in your aquarium do not exceed 480 to 500 mg/l.

It has long been known in a reef aquariums that the inhabitants are constantly in need of calcium to build their skeletons and shells. Administering ROWAkalk to your aquarium will enhance pH as well as binding phosphates, therefore enhancing protein skimming.  ROWAkalk is the ideal supplement mix for producing kalkwasser.

Calcium hydroxide should only be administered after the calcium hydroxide (kalkwasser) mix has cleared.  The cleared and fresher the solution, the better the results.  Mechanical stirrers are highly recommended to dose kalkwasser.

To obtain the best results, you should use DO or RO water.  Dosing should take place at the lowest point of the pH cycle.  This normally being at night approximately 5 to 6 hours after the light have been turned off.  Attention should be paid to the pH when dosing as it could rise to dangerous levels if administered to fast.

The pH of calcium hydroxide when first mixed in RO or DI water should be 12.45.  The marine aquarium environment should never have a pH exceeding 8.5 and when over dosing kalkwasser, this could be exceeded if care and attention is not paid.